Ramuc Hi-Build Epoxy Pool Paint 2 Gallon Kit

Ramuc Hi Build Epoxy Pool Paint is a high-build, two-component epoxy system that provides long-lasting protection for concrete, plaster, and fiberglass surfaces. Its thick, durable satin finish resists stains, chemicals, and abrasion, making it ideal for pools, spas, slides, and high-use aquatic facilities. With a 1:1 mix ratio and self-priming formulation, it offers excellent coverage and surface-smoothing properties. Two coats can deliver up to 8 years of service life, making it a cost-effective alternative to replastering.

Why Choose Ramuc Hi Build Epoxy Pool Paint?

• Long-Term Protection: Offers up to 8 years of service life with excellent resistance to stains, chemicals, and abrasion.
• Surface Smoothing Qualities: Builds up to 8 mils per coat, helping to level and seal rough or aged pool surfaces.
• Easy 1:1 Mix Ratio: Pre-measured components simplify mixing and ensure consistent results.
• Self-Priming System: No additional primer required - two coats provide complete coverage and bonding.
• Alternative to Replastering: Renews pool surfaces at one-third the cost of traditional resurfacing.
• VOC Compliant: Safe for use across the U.S. and Canada in regulated environments.

Quantity Calculator

Use the table below to type in the dimensions of your project area, then click the Calculate button to determine the amount of Ramuc product needed for the job.

Surface Preparation & Application

• Inspect Surface: Ensure concrete, plaster, or fiberglass is structurally sound and free of loose, weak, or crumbling areas. Repair defects using hydraulic cement or appropriate patching compound.
• Clean Thoroughly: Use Ramuc Clean and Prep Solution to remove grease, oils, scale, and other contaminants. This also opens the surface pores to promote coating adhesion.
• Abrade as Needed: For previously coated epoxy or fiberglass surfaces, sand thoroughly with 60–80 grit paper to create a uniform profile for adhesion.
• Perform Condensation Test: Ensure surface is completely dry before painting by taping 2'x2' plastic sheets to various areas. After 4 hours, check for trapped condensation. Do not paint if moisture is present.
• Mix Properly:
  • Pre-mix Part A and Part B separately for 5 minutes each using a mechanical drill mixer until fully uniform in consistency.
  • Combine Part A and Part B in a 1:1 ratio by volume (e.g., pour the entire contents of one Part A can into one Part B can). Mix thoroughly for 20 minutes using a drill mixer. Hand-mixing is not recommended.
  • Allow the mixed product to stand (induction time) for 20 to 45 minutes at 70°F (21°C) and 50% relative humidity before application.
• Apply Two Coats: Apply with a 3/8” mohair or lambskin roller. Wait 16–72 hours between coats. If recoating after 72 hours, sand the surface before the next coat to ensure adhesion.
• Control Environment: Apply only in dry conditions with air and surface temperatures above 50°F (10°C). Avoid application in high humidity or when rain is expected within 24 hours. Allow at least 5–7 days for full curing before filling the pool with water.

Not Recommended For

• Use on uncured plaster or concrete (must be fully cured for at least 28 days)
• Painting in rain, fog, or high-humidity conditions
• Use with silicone-based sealants or unetched smooth fiberglass surfaces
• Full-pool application of dark colours - recommended for accent use only due to potential fading or excessive heat absorption